Arbiter Systems 1040C - Page 72

2-33
Table 2.9 - Diagnostic Test Error Codes (continued)
_____________________________________________________________________________
TEST ERROR DESCRIPTION
##
_____________________________________________________________________________
07 Voltage Measurement Test
0 Measurement Offset Adjustment Error
1 Reference Measurement Error
2 AC Gain Measurement Error
3 Overload Circuit Test Error
4 100 mV Range Measurement Error
5 1 V Range Measurement Error
6 10 V Range Measurement Error
7 100 V Range Measurement Error
8 1000 V Range Measurement Error
08 Voltage Source Test
1 Voltage Generator Attenuator Test Error
2 AC Operation Failure
09 Hand Held Unit Test
No error report. Operator cued to press Front Panel Buttons.
Test if the button tested is inoperative, if all buttons are
tested and operate, PASS message displayed (pass code is
reported via GPIB if the test was requested over GPIB).