19
3. Press and hold the gun trigger to load the wire through the
gun, until the wire feeds through the end of the Gun.
NOTE:
Before feeding, Remove the nozzle and contact tip before
feeding the wire to ensure smooth wire feeding.
If the wire does not feed properly and the Spool is
stationary, turn OFF and unplug the Welder and slightly
tighten the Feed Tensioner clockwise before retrying.
If the wire stops instead of bending, disconnect the
Welder, tighten the Feed Tensioner slightly clockwise,
and try again. If the wire bends due to feed pressure, the
tension is set correctly.
Point the Gun away from all objects.
4.Turn off the machine after the wire stick out. Then install the
nozzle and contact tip.
NOTE:
Cut the wire 3/8” to 5/8” from the end of the tip.
5.Turn on the machine. The machine is now ready to weld.
6.Close the Door. Make sure. Door is securely latched.
6.4 Operation
! WARINING BEWARE OF ELECTRIC SHOCK!
Turn on the power switch of the machine, and the power indicator illuminates.
Select proper working mode and proper function according your welding situation.
Function with synergic Part Select
Select MIG
Select wire
diameter
Figure 27
Figure 28
https://www.arccaptain.com/
To Next Page
