ARCCAPTAIN MIG160 - Operation for MMA and TIG; MMA Welder Cable Connection

20
Turn the knob to find the required current
 Clamp the Ground clamp onto the workpiece, The Ground clamp must be securely connected to the
workpiece.
NOTICE:
• Always weld clean, dry and well-prepared material.
•
Hold gun at a 45° angle to the
workpiece with nozzle about 1/2” from
the surface.
• Move the gun smoothly and steadily as
you weld.
•
On thin gauge material, move quickly
and only weld 1/4” stitch-welds at a
time to avoid melt-through.
• Avoid welding in very drafty areas. A
weak, pitted and porous weld will result due to drafts blowing away the
•
Keep wire and liner clean. Do not use rusty wire.
• Sharp bends or kinks in the welding cable should be avoided
•
ONLY use Flux Cored MIG welding wire.
• Flux core MIG Welding parameters table（for reference only）
7. Operation for MMA and TIG
! WARINING DO NOT set up without SWITCH OFF !
7.1 MMA Welder Cable Connection
NOTICE: Before setting up or using this product for new function,
make sure to read the entire Important Safety Information section at
the beginning of this manual!
Figure 29
https://www.arccaptain.com/