30
Forced Defrost
In heating mode, press and at the same time to run defrost mode, and the defrost
icon will
flash.
Clock Setting
Short-press the time button , and the time of the wire controller will flash. At this time
press button to confirm, and the hours will be flashing. Press or to change the
hours. Press button again to change the minutes. When correct, press button to
set the new time and exit setting.
Timer ON/OFF Settings
While in standby status, long-press time button , the icons and hours will flash.
Now press or to change the on-time hours. Short press again, and the time for
on-time minutes can be changed. Now you have finished the unit on-time setting. Then
short-press the button and and hours will flash. Now press or to change
the off-time hours. Short press again and the off-time minutes can be changed. Short-press
button one more time to finish the timer settings and exit. (see sequence diagram next page)
Cancelling Timer Operation
Cancelling the timer operation implies that the timer will not interrupt the operation of the heat
pump. To cancel the timer Long press the button, entering the timer setting, and then press
the button.
Changing Between Celsius & Fahrenheit
To switch between ℃ and ℉, long-press the function button and ON/OFF button at the
same time until it changes.
To Next Page
Loading...