Argox X-2300 - Page 45

45
MASK
When DHCP is disabled, default IP
address is 192.168.1.100.
If “_” sign appears, that means that
DHCP setting is disabled. On the
contrary, DHCP setting is enabled.
1. FEED/CONFIG. :
change contents.
(ex. from 000.000.000.000 to
255.255.255.255)
2. PAUSE/CALIBR. :
shift “_”sign position.
(ex. from 255.255.255.255 to
255.255.255.255)
3. CANCEL/RESET.:
Select next function setting. (“_”
sign must at the third digit of each
parameter, for example, xxx).
4. To change IP ADDRESS or
SUBNET MASK, enter DEFAULT
GATEWAY setting, press CANCEL
button once; LCD will prompt
“ETHERNET CARD UPDATE
FINISH…”
Then reboot the printer.
DEFAULT
GATEWAY
xxx.xxx.xxx.xxx
MAC
ADDRESS
yyyy-yyyy-yyyy
(yyyy = 0000~FFFF)
To have more information on Ethernet settings, please refer to
Ethernet User’s Guide.