Argox X-2300 - Page 44

44
graphics stored will be
deleted.
SETTING
PRIORITY
COMMAND/
LCD PANEL
COMMAND
Choosing priority of
LCD settings. It
decides which setting
method - by command
or by LCD panel, is
prior.
Ethernet settings and parameters
(X-2300E. X-2300ZE. X-3200E. X-3200ZE):
Item
Range
Factory
Default
Remarks
DHCP
DISABLE
ENABLE
If printer has been connected to a
router, IP address will be assigned
automatically by DHCP server after
power on.
If printer is not connected to a
router, with DHCP disabled,
settings of IP ADDRESS, SUBNET
MASK, and DEFAULT GATEWAY
settings will be available on LCD.
Every time when DISABLE is
changed to be ENABLE, LCD will
prompt “ETHERNET CARD
UPDATE FINISH…”
Then please reboot the printer.
IP ADDRESS
xxx.xxx.xxx.xxx
xxx range:0~255
SUBNET
xxx.xxx.xxx.xxx