Chapter 3: Configuration and commissioning
48 2X Series Installation Manual
Locating devices
Select the Locate device option to activate a loop device LED. This helps to
identify the location of a device in the installation. You will need the Firenet ID of
any remote device LED to be activated.
To locate a device:
1. Select Test from the Main menu, and then select Locate device.
2. Select the loop number, All loops, or Remote (if Remote is selected, enter the
Firenet ID, loop number, and device address when prompted).
A list of all the devices on the selected loops is displayed.
3. Select the corresponding device, and then press the jog dial to activate the
device LED. To turn off the device LED, press the jog dial again.
4. Press F2 (Exit) to exit the menu.
Testing remote features or devices
Select the Remote test option to test remote features or devices. You will need
the Firenet ID of the remote feature or device to be tested.
To test remote features or devices:
1. Select Test from the Main menu, and then select Remote Test.
2. Select Panel and enter the control panel Firenet ID.
3. Select Element, and then select Device, Group, or Zone. Enter the device
loop and address information, the group number, or the zone number.
For devices enter the loop number and the device address in the format
L.DDD (for example, 1.089 for device 89 on loop 1).
4. Select Active then select YES (to start the test) or NO (to stop the test).
5. Press the jog dial again to end the test.
6. Press F2 (Exit) to exit the menu.
Testing batteries
Select the Battery test option to test the batteries. For more information on
battery status messages, see “Battery maintenance” on page 107.
To test the batteries:
1. Select Test from the Main menu.
2. Select Battery test.
A message confirming battery status displays on the LCD.
3. Press F2 (Exit) to exit the menu.
To Next Page
Loading...
Need help?
General
