Aritech 2X Series - Appendix A Default configurations; Default configurations

2X Series Installation Manual 117
Appendix A
Default configurations
The following table shows the settings for the default configuration of your panel.
Table 63: Default configurations
Description
Default setting
Power supply
operation 230 VAC
Control panel ID
01
Day/
night mode Full day to day mode
Control panel network operation
Stand-alone
Network
global commands Yes
Network mask
0 (all panels excluded from the mask)
Repeater panel network operation
Repeater
Repeater m
ask All panels repeated
IP address
192.168.104.140
Subnet mask
255.255.255.0
Gateway
0.0.0.0
Port
2505
24V auxiliary
Not deactivated during reset, not deactivated when running
on batteries
Fault
mask All faults are reported
Sounders re
-sound Sounders re-sound
Expansion boards
for repeater
panels
Network board is configured
Initial zone
1
Autosetup zone
All detectors, manual call points, and zone modules to the
initial zone
All sounders to output group 1 (sounders)
All relay/non-supervised outputs to output group 301
(program)
All extinguishing modules to output group 801
(extinguishing)
All inputs configured as technical alarm latched