Aritech 2X Series User Manual

Chapter 3: Configuration and commissioning
72 2X Series Installation Manual
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select Other settings, and then select DACT config.
3. Select CMS config, and then Select the CMS to configure (1 to 6).
4. Configure all required settings.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
PSTN configuration
Select the PSTN configuration option to configure public switched telephone
network settings. Configuration options are shown in the table below.
Table 33: PSTN configuration options
Option
Description Default value
Ccode
Configures the PSTN country code [1] 099
Line 1
Enables or disables line 1 [2] Disabled
Line 2
Enables or disables line 2 [2] Disabled
Retries
Configures the maximum number of times the
number is dialled
05
Kissoff
Configures the kiss-off acknowledgement time 48 x 10 ms
[1
] See Appendix B “PSTN country codes” on page 119 for a complete list of country codes.
[2] These correspond to the line 1 and line 2 connectors on the installed DACT board.
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select Other settings, and then select DACT config.
3. Select PSTN config.
4. Configure all required settings.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.

Aritech 2X Series Specifications

General

Certifications	EN54-2, EN54-4
Power Supply	230V AC, 50Hz
Battery Capacity	7Ah
Current Consumption	Standby: 50mA
Humidity Range	Up to 95% RH, non-condensing