22 CS450 User Manual
Codes
• The CS450 has 4 types of code
• The code tells the system what rights you have.
These are known as privileges. Permission to
carry out tasks is linked to these privileges
User Codes 8 of these can be assigned.
Each user code will have a
unique number.
Duress Code This is used when you are forced
to disarm the system unwillingly.
The alarm system will be
switched off. If you have a
dialler connected a message will
then be sent to the alarm
company.
Engineer Code This is used by the installer.
Code 8 Code 8 is the eighth user code.
It can be used as a normal user
code or as a temporary code.
The temporary code is called the
Code Count.
It is used to give access to
someone for a short period of
time. You can program the
system to accept the code only
once or up to 98 times.
When the code count is set to
99, code 8 will always work. If it
is set to 0, the code will not work.
To Next Page
Loading...
