CS450 User Manual 27
User Privileges
• User privileges tell the alarm system which parts
you can access. Your user code must have the
correct privileges assigned to it to carry out the
task. If it does not, contact your installer.
• You can only assign privileges if you have the
‘Mg’ privilege.
• It is not possible to assign privileges which you do
not possess.
User Privileges
Fs Turn on alarm system
Ps Turn on partguard 1
Turn on partguard 2
Us Turn off alarm system.
In Inhibit zones
Turn on forced arming
Mg Do chime/bell test
Change all codes
View engineer log
Alter time and date
• The installer should leave one code with the Mg
privilege assigned to it. The user of that code
should then assign codes and privileges as
necessary.
• Most users will only need Fs and Us.
To Next Page
Loading...
Need help?
General