CS450 User Manual 9
Arming with
inhibited zones
If a zone is open the alarm
system cannot be switched on
until the zone has been
inhibited. This means that the
zone, for example the kitchen,
is left unguarded but the rest of
the premises will be guarded.
Only inhibit zones when
absolutely necessary.
If an open zone has the letter T
in front of it on the display, it is
a Tamper zone. This means
that the alarm system itself has
been tampered with in some
way. Zones cannot be inhibited
if tampering has occurred and
you must contact the installer.
After disarming, all the inhibited
zones are shown in the
Operator Log
Forced Arming This switches on the system
when a number of zones are
open without having to inhibit
each one individually.
Zones which cannot be inhibited
individually cannot be inhibited
by forced arming.
Zones cannot be inhibited if
tampering has occurred.
To Next Page
Loading...
Need help?
General