Figure 52
Figure 53
Figure 54
SELECT MODE36
Transport mode
Activate (1 step)
To activate the Transport mode, disconnect the tube
set during use.
• Press the side buttons on the connector
simultaneously and remove the tube-set.
See Figure 52
When the tube-set is disconnected from the Auralis
pump during use, the Auralis mattress supports the
SDWLHQWIRUKRXUVZLWKRXWGHÀDWLQJ
See Figure 53
WARNING
To avoid injury, disconnect the power
cable from the power source before
moving the bed.
CAUTION
To avoid entanglement when the Auralis
pump is in Transport mode, make sure
that the tube-set connector is stowed
appropriately.
NOTE
There is no Transport mode on the Auralis seat
cushion.
Deactivate
To deactivate the Transport mode, connect the tube-
set. The Auralis pump goes back to the previous
mode by default. See Figure 54
Continue on the next page
To Next Page
Loading...
