Arjo Auralis - Product description - Auralis pump; Control panel overview

Figure 3
Figure 4
Figure 2
Figure 5
PRODUCT DESCRIPTION - AURALIS PUMP
17
NOTE
There are three different indicator colours:
• Green indicators are functions
• Yellow indicators are information signals or alarms
• Blue indicators are battery charging
Control panel
Run/Standby button
The Run/Standby button (see Figure 2) switches the
Auralis pump between run mode and standby mode.
Run mode - press the button once. The indicator
FKDQJHVIURPÀDVKLQJWRFRQVWDQW
Standby mode - press the button for two seconds.The
LQGLFDWRUFKDQJHVIURPFRQVWDQWWRÀDVKLQJ
NOTE
To turn the Auralis pump off during power failure
or battery operation, press the Run/Standby
button for four seconds.
Wait indicator
The Wait indicator (see Figure 3) is shown when the
$XUDOLVPDWWUHVVRUVHDWFXVKLRQLVEHLQJLQÀDWHG7KH
indicator remains on for approximately 15 minutes
until the Auralis mattress or Auralis seat cushion
LVIXOO\LQÀDWHGDQGUHDG\IRUXVH7KH$XUDOLV3OXV
mattress takes approximately 17 minutes to reach full
LQÀDWLRQ
$XWR¿UPPRGHEXWWRQ
7KH$XWR¿UPPRGHVHH)LJXUHLQÀDWHVWKH$XUDOLV
PDWWUHVVWRDWHPSRUDU\¿UPVXUIDFHDOORZLQJWKH
QXUVLQJSURFHGXUHVWREHSHUIRUPHG7KH$XWR¿UP
mode lasts for 15 minutes but may be increased in
5 minute steps to a maximum of 30 minutes. When
activated the indicator is shown. The Auralis seat
FXVKLRQGRHVQRWKDYH$XWR¿UPPRGH
Alternating mode button
The Alternating mode (see Figure 5) is set by default.
Product description - Auralis pump