Arjo Auralis - Start the Auralis system; System start-up procedure

Figure 45
Auralis
Figure 46
START THE AURALIS SYSTEM32
Start the Auralis system
Before using any of the Auralis mattress or Auralis
seat cushion systems make sure:
• The Auralis system is assembled correctly in
accordance with
VHFWLRQ³$VVHPEOHWKH$XUDOLV
V\VWHP´RQSDJH
• 7KH&35UDSLGGHÀDWLRQXQLWRQWKHPDWWUHVVLVLQ
closed position.
Auralis system start-up
(5 steps)
When the Auralis pump power cable is connected
to a power source, the Auralis pump sounds with
a start-up tone and a self-diagnostic check runs
for 10 seconds. Once the check is completed the
Auralis pump beeps twice and is ready for use.
1. Press the Run/Standby button on the control
panel for 2 seconds.
The following indicators are shown:
• Run/Standby
• Wait indicator
• Alternating mode button
• Comfort control indicator
• Battery charge indicator
• Green indicators on the front of the pump
See Figure 45
7KH$XUDOLVPDWWUHVVLVIXOO\LQÀDWHGZKHQWKH:DLW
indicator is off, after approximately 15 minutes.
The Auralis Plus mattress takes approximately 17
PLQXWHVWRUHDFKIXOOLQÀDWLRQ
2. When the Auralis PDWWUHVVLVIXOO\LQÀDWHGLIDEHG
VKHHWLV¿WWHGWXFNLWLQORRVHO\0DNHVXUHWKDWWKH
&35UDSLGGHÀDWLRQXQLWLVFOHDUO\YLVLEOHDWWKH
head end of the bed.
3. Place the patient on the Auralis mattress with the
head at the head end and the feet at the foot end.
See Figure 46
Continue with steps on the next page.
NOTE
The Auralis pump automatically adjusts the
pressure in the mattress to support the patient.