Arjo Auralis - Turn off and store the Auralis system; Pump shutdown procedure; Mattress deflation and storage

Figure 58
Figure 59
Figure 60
TURN OFF AND STORE THE AURALIS SYSTEM38
Turn off and store the Auralis system
Turn off the Auralis pump
(3 steps)
1. Press the Run/Standby button for 2 seconds.
The Auralis pump enters Standby mode.
2. Disconnect the power cable from the power
source.
3. To turn off the Auralis pump completely, press the
Run/Standby button for 4 seconds until a double
beep is heard.
'HÀDWHDQGVWRUHWKH$XUDOLVPDWWUHVV
(6 steps)
1. Clean and disinfect the mattress according to
VHFWLRQ³&OHDQLQJDQGGLVLQIHFWLRQLQVWUXFWLRQV´RQ
page 40.
2. $FWLYDWHWKH&35UDSLGGHÀDWLRQXQLWWRGHÀDWHWKH
Auralis mattress.
3. Place the tube-set over the Auralis mattress
parallel to the foot end. See Figure 58
4. Roll the Auralis mattress tightly, allowing it to
GHÀDWHVRLW¿WVLQWRWKHEDJ6HH)LJXUH
Start from the foot end and continue up to the
&35UDSLGGHÀDWLRQXQLWDWWKHKHDGHQG)RU
$XUDOLV3OXVRQO\GHÀDWHEROVWHUVEHIRUHUROOLQJ
5. Place the Auralis mattress in the protective bag.
See Figure 60
The inside of the storage bag should be dry, clean
and
free from contamination and sharp objects.
6. Store the Auralis mattress in a designated area, in
OLQHZLWKVWRUDJHUHTXLUHPHQWVVHH³7UDQVSRUWDQG
VWRUDJHFRQGLWLRQV´RQSDJH
WARNING
To avoid cross-contamination, always
clean and disinfect the Auralis system
after each patient.