31
Electromagnetic Compatibility
Product has been tested for compliance with current regulatory standards regarding its capacity to block EMI
(electromagnetic interference) from external sources.
Some procedures can help reduce electromagnetic interferences:
• Use only Arjo cables and spare parts to avoid increased emissions or decreased immunity which can compromise the
correct functioning of the equipment.
• Make sure that other devices in patient-monitoring and/or life-support areas comply to accepted emissions standards.
Intended Environment: Home Healthcare Environment and Professional Healthcare facility environment.
Exceptions: HF Surgical Equipment and the RF Shielded room of an ME SYSTEM for magnetic resonance imaging.
Guidance and manufacturer’s declaration – electromagnetic emission
Emission test Compliance Guidance
RF emissions CISPR 11 Group 1 This equipment uses RF energy only for its internal functions.
Therefore its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
RF emissions CISPR 11 Class B This equipment is suitable for use in all establishments, including
domestic establishments and those directly connected to the public
low voltage power supply network that supplies buildings used for
domestic purposes.
Guidance and manufacturer’s declaration – electromagnetic immunity
Immunity test IEC 60601-1-2 test level Compliance level
Electromagnetic
environment –
guidance
Electrostatic
discharge (ESD)
EN 61000-4-2
±2kV, ±4kV, ±8kV, ±15kV air
±8kV contact
±2kV, ±4kV, ±8kV, ±15kV air
±8kV contact
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Warning: Wireless communications equipment such as wireless computer network devices, mobile
phones, cordless telephones and their base stations, walkie-talkies, etc. can affect this equipment and
should be kept at least 1.5 m away from the equipment.
Warning: Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment and the other
equipment should be observed to verify that they are operating normally.
To Next Page
Loading...
