Armfield PCT40 - Operation; Operating the PC Software; Operating the Equipment

36
Operation
Where necessary, refer to the drawings in the Equipment Diagrams section.
Operating the PC Software
Details about operating the software can be obtained by choosing the ‘Help’ tab in
the top right hand corner of the screen as shown below:
Operating the Equipment
Note: Before operating the equipment ensure that it has been correctly installed in
accordance with the Installation Process, and that you have read the Important
Safety Information at the beginning of this manual.
Switching On
Before operating the apparatus, check that the RCD and circuit breakers at the back
of the equipment are in the ON (up) position:
The on/off switch for the apparatus is located on the orange panel on the front of the
plinth.
Note: The red and green LCD indicators on the front of the plinth are associated with
the USB connection to the PC. These may be lit even if the PCT40 unit itself is
switched off.