3 | Safety Instructions
16 SkyPanel X Operating Manual
WARNING
Humidity and Condensation
Risk of electric shock and fire hazard caused by short circuit.
u Never expose the device to rain or moisture in a fixed installation for a long time.
u Do not immerse the device in any liquid.
u Do not use the device for 2 h when it was exposed to big temperature differences as
condensed moisture may damage the device electrically when switched on.
u Do not bend the power cable directly after the connector. Water could immerse and cause
short circuits and damage the connector.
WARNING
Overheating
Risk of skin burns and fire hazard.
u Do not operate the device if the ambient temperature exceeds +40° C / 104° F.
u Intensive use can cause the surface to become hot (up to VARIABLE). Let the device cool
down completely before you handle it.
u Never cover air vents during operation. Keep a minimum clearance around the air vents of
20in/0.5m.
u Never point an intense light beam from light source to the device.
u Do not place the device on or nearby heat sources. Intense heat cause damage to the device
or automatic power off during operation.
WARNING
Intense light
Risk of injury and fire hazard.
u Do not stare at an operating light source.
u Do not stare at the light output aperture. Risk of irreversible eye injury. Wear safety glasses.
Keep a minimum distance to an illuminated surface, objects or persons of 1.0 m / 40in .
u The device must not be used without a diffuser or intensifier installed.
Photobiological Safety
Risk Group 1
*
product according to EN 62471 and IEC/TR 62778.
The SkyPanel X device falls into the following risk groups according to EN 62471 and IEC/TR 62778
at the distances indicated below.
No photobiological hazard under normal behavioral limitation.
DO NOT
EXPOSE
RISK
GROUP 2 GROUP 1
RISK RISK
GROUP 0
Distance 0.75 m / 2.46 ft0.2 m / 0.66 ft 4.0 m / 13.1 ft
*
The risk group listed here applies to the minimum distance specified. Further information regarding
hazards due to optical radiation are present and can be requested from your dealer if necessary.