EasyManuals Logo

ARRI SkyPanel X User Manual

ARRI SkyPanel X
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
6 | Basic Operation
38 SkyPanel X Operating Manual
The device will operate with the settings made on the control panel or received by DMX / RDM, Art-
Net or sACN.
Please observe the information in the following section.
6.5 Reset Procedure
Magnetic switch
Illustration15: Position of magnetic reset switch
Soft Reset
If the device no longer responds to control
signals, you can perform a soft reset. The soft
reset is carried out when you activate the
magnetic switch (see adjacent picture) for at least
5 s.
To perform a soft reset:
Hold the control panel magnet over the spot
marked in the picture for at least 5 sec.
How to position the magnet on the control
panel to activate the magnetic switch:
Slide the control panel with the magnet
towards the device and the encoder
facing downwards into the gap between
the left yoke bracket (seen from the back)
and the device.
Push the control panel up and forward as
far as it will go.
Remove the magnet or control panel once
the status LED turns red. The soft reset will
be executed.
The soft reset is completed after a short time
and the device is ready for operation.
If the device does not work after a soft reset,
do a hard reset.
Hard Reset
Power cycle the device to perform a hard reset.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ARRI SkyPanel X and is the answer not in the manual?

ARRI SkyPanel X Specifications

General IconGeneral
BrandARRI
ModelSkyPanel X
CategoryLighting Equipment
LanguageEnglish

Related product manuals