Maintenance, Cleaning and Repair | 8
SkyPanel X Operating Manual 41
8 Maintenance, Cleaning and Repair
8.1 Maintenance
WARNING
Read the safety information before maintaining the device.
WARNING
Intense Light
Risk of injury. The device can light up suddenly when connected to power.
u Disconnect the device from mains power before handling.
u Do not stare into the light output aperture. Wear safety glasses.
WARNING
Hot surface
Risk of burning. The device becomes hot during operation.
u Disconnect the device from mains power before handling.
u Let the device cool down completely before handling.
WARNING
High Voltage
Risk of injury. The device contains components that are accessible and live at high voltage while the
device is connected to power.
u Disconnect the device from mains power before handling.
u Some components can remain under tension for 30 min. after power is disconnected.
u Only a certified ARRI service center is permitted to open the device.
NOTICE
Excessive dust, smoke fluid and particle buildup degrades performance. It causes overheating and
will damage the device. Damage caused by inadequate cleaning or maintenance is not covered by
the product warranty.
You can carry out external cleaning as described in this section. Follow the warnings and
instructions provided. Any service operation not described in this operating manual or in the user
manual must be referred to a certified ARRI service center.
Clean the device periodically. You may also upload firmware to the device via the Ethernet
connector or the USB port using firmware and instructions from ARRI. All other service operations
on the device must be carried out by a certified ARRI service center.
The global ARRI service organization and its approved agents can provide on-site service and
maintenance. They give you access to ARRIs expertise and product knowledge in a partnership that
will ensure the highest level of performance throughout the product’s lifetime. Please contact ARRI
for details.
To Next Page
Loading...
Need help?
General
