Product Overview | 4
SkyPanel X Operating Manual 19
4 Product Overview
The light source of the SkyPanel X is located behind a sealed protective glass. The device is
equipped with accessory mounts on all four corners on the front.
There are two yoke brackets with quick-release levers on the left and right side of the device.
The large heat sink is located between the housing of the light source and the housing for the
integrated power supply unit, fan and power electronics.
The device is waterproof according to IP 66. A climate membrane is located at the back to equalize
the pressure when the device heats up and cools down. The fans between the electronics housings
comply with protection class IP 66. A perforated sheet metal protects the fans from damage.
On the back of the device is the control panel recess and the connector panel.
The control panel connects automatically to the SkyPanel X when inserted into the recess. It is held
in place magnetically.
All connections are provided with protective rubber caps or correspond to protection class IP 69
(LEMO connector). The protective caps must be mounted if a connection is not used to comply with
protection class IP 66.
To Next Page
Loading...
Need help?
General
