6-26 CHP Max™ Headend Optics Platform Chassis, Controllers and Power Supplies 1508685 Rev D
On When this radio button is selected, the auto-configuration mode is
enabled.
Off When this radio button is selected, the auto-configuration mode is
disabled. Factory shipped with auto-configuration disabled.
Enable Manual Status
Unlock When this radio button is selected, the Local Control radio button on each
application module enables or disables the front panel controls on the
application modules.
Lock When this radio button is selected, the Local Control radio button on the
GUI of each application module within that shelf is forced to the Lock
mode, disabling the front panel controls of each application module
within that shelf. If the Local Control radio button on a particular
application module is then set to Unlock, the front panel controls on that
application module (except for the CHP-XMOD) will be enabled for
approximately 3 minutes. After 3 minutes, the Local Control radio buttons
on this application module will automatically go back to the Lock mode,
disabling front panel controls on this module.
Relay Status
Disabled Relay is disabled.
Enabled on All Alarms Relay is enabled on major and minor alarms.
Enabled on Major
Alarms
Relay is only enabled on major alarms.
Enabled Relay is always enabled.
Module Identity tab
This tab only provides status. Refer to Figure 6.16 on page 6-27 to see the various module
parameters.
Alarms tab
This tab lists all major and minor alarms as shown in Figure 6.17 on page 6-27.
Table 6.3 Controls and Functions of the Craft Management Software (cont’d)
Control Function
To Next Page
Loading...
Need help?
General
