6-36 CHP Max™ Headend Optics Platform Chassis, Controllers and Power Supplies 1508685 Rev D
Figure 6.26
SMM File Directory
3. As shown in the following window, type the ftp command followed by the IP
address of your SMM module. The SMM will show that the FTP session is connected.
Figure 6.27
SMM FTP Session
4. The FTP session user name is CCOR, and the default password is CCOR. The FTP
password is the same password used for a Telnet session and can be changed using
the Telnet password command.
5. In the FTP program, the “dir” command will tell you the files that are currently on the
SMM along with the file sizes and dates.
6. To put a file from the local PC directory you simply type in the command “put”
followed by the file name that you want to send from the PC to the SMM.
7. After the file is finished downloading, the Transfer complete message will be
displayed and the SMM is ready to be reset from a Telnet window to run the new
software release.
To Next Page
Loading...
Need help?
General
