Rev D System Management Module 2 (SMM-2) 7-31
Figure 7.27
Device Manager
Window
5. Press the Enter key and a login prompt will appear in the PuTTY terminal for logging
into the SMM-2.
6. At the login prompt, type admin, then press the Enter key.
7. At the password prompt, type admin, then press the Enter key.
To set the network information, proceed as follows:
1. After login, at the admin@192.168.1.1> prompt, type configure and press the Enter
key.
2. At the admin@192.168.1.1% prompt, type set interfaces and press the <TAB> or
<SPACE> followed by ? to view all the parts of the IPv4 address command:
eth0 sets the IPv4 address
mask sets the IP subnet mask
gateway sets the default gateway
3. Press the Enter key after the all of the network information is complete
Note The admin@192.168.1.1> prompt is an example and the prompt you are likely
to see will be different.
To Next Page
Loading...
