15A3356O 36
6.10 Signature Block (available in version 7A2.1XX or newer firmware)
The Signature Block menu entry allows the display “Performed By:” and
“Reviewed By:” signature lines to appear on the Printout. Each line will
also contain a “Date:” section for recording the date. Access this option
using the Setup Menu. (Refer to Section 6.1, “Instrument Setup Menu.”)
Press YES at the prompt:
Setup Menu
Signature Block?
To skip this setup option, press NO.
If YES is pressed, the following prompt will be displayed:
Sig block: Omit
Change? (Yes/No)
or
Sig block: Include
Change? (Yes/No)
These prompts indicate whether the signature block is currently omitted
from, or included in, the printout.
Press NO to keep the Signature Block setting as displayed. Press YES to
change the Signature Block setting to the alternative selection. See
Appendix B for an example Printout.
To Next Page
Loading...
