15A3356O 5
Paper Feed Switch. Pressing this switch feeds the paper
continuously. Paper feed will work only when the OFF LINE
indicator illuminates or flashes.
On Line/Off Line/Paper End Switch. Pressing this switch shifts
the Printer from ON LINE to OFF LINE and vice versa. When ON
LINE, the Printer is ready to receive instructions from the
Instrument. The Printer cannot be turned ON LINE if paper is not
loaded.
2.4.2 Loading Printer Paper
Turn the Power Switch to the ON position.
Open the paper cover located on the top right hand side of the
Printer.
Cut the end of the paper roll cleanly and squarely.
Insert the end of the paper into the inlet at the bottom of the paper
holder until the auto-loader catches it and feeds it through. The
outside of the roll is the printable surface for the thermal paper roll.
Close the paper cover.
NOTE: A red line will appear on both sides of the paper when the paper roll nears
depletion. This indicates that the paper roll should be changed.
2.4.3 Preparing the Printer for Pipette Calibration
Once the paper roll is in place, the Instrument and the Printer can
be turned ON. When the ON LINE light is green, the printer is ready
for operation.
NOTE: Refer to the printer operation manual for more detailed information.
2.5 RS232 Port
Refer to Section 6.7, “Serial Data Output,” for information on use of the
RS232 port.
To Next Page
Loading...
