ARTEX/ACR Electronics, Inc.
A3-06-2824 Handheld Programmer Operations Manual
Y1-03-0272 Rev. F Company Confidential Page 31
7. You may then click on the other number system selection to see the converted
value (Octal or Hex).
NOTE: The 3-digit country code is automatically determined from the country
data encoded in the 24-bit address.
8. Go to Graffiti screen and tap on letter/numbers.
9. Enter aircraft 24-bt address.
10. Tap “Done” when finished.
11. Tap “ENTER” button on Program screen. The 32-digit hex code is shown at the
bottom of the screen, with the abbreviated 15-digit hex code below it.
12. For ELT 345s or ELT 1000s only: tap “Program”; quickly place ELT switch in
the test mode and release. (Quickly is <1 second).
13. Tap the “Program” button to program the ELT.
14. Ensure that screen shows “Programming Successful”.
15. Verify ELT using Sarcalc”, as described in Subsection 6.2.
4.7.11 Std Location / ELT Serial (Long)
1. Select ELT Baud rate.
2. For the ELT 345 and ELT 1000, refer to Note 1 on page 23 before continuing.
3. For the ELT 3000 and ELT 4000, refer to Note 2 on page 23 before continuing.
4. Select Protocol.
5. Select Country Code.
6. Go to Graffiti screen and tap on letter/numbers.
7. Enter the serial number, which matches the serial number seen on the product
label, or a number that was designated for use by the competent national
authority.
8. Enter the COSPAS-SARSAT TAC number.
9. Tap “Done” when finished.
10. Tap “ENTER” button on Program screen. The 32-digit hex code is shown at the
bottom of the screen, with the abbreviated 15-digit hex code below it.
11. For ELT 345s or ELT 1000s only: tap “Program”; quickly place ELT switch in
the test mode and release. (Quickly is <1 second).
12. Tap the “Program” button to program the ELT.
13. Ensure that screen shows “Programming Successful”.
14. Verify ELT using “Sarcalc, as described in Subsection 6.2.
To Next Page
Loading...
