ARTEX/ACR Electronics, Inc.
A3-06-2824 Handheld Programmer Operations Manual
Y1-03-0272 Rev. F Company Confidential Page 38
5.4 ELT 3000/ELT 4000 PA Software Operation
The PA is programmed in the exact same manner as the ELT 3000 or ELT 4000 Series.
The reason for this is that the PA holds programming identical to the programming in
the attached ELT, and simply updates the ELT if there is a difference.
To program an ELT 3000 or ELT 4000 series PA, follow the ELT programming
instructions in Section 4, except select ELT 3000 or ELT 4000 PA. Select the protocol
intended for the ELTs that will be attached to the PA in the aircraft.
1. Enter programming information for protocol being used.
2. Refer to Note 2 on page 23 for selecting options.
3. Tap “ENTER” button on screen.
4. The 32-digit Hex code or 24-digit Hex code is shown at the bottom of the screen
with the abbreviated 15-digit Hex code below it.
5. Tap the “PROGRAM” button to program the PA.
6. Ensure the screen shows “Programming Successful”.
7. Verify the programming using Sarcalc, as described in Subsection 6.2.
To Next Page
Loading...
