ARTEX/ACR Electronics, Inc.
A3-06-2824 Handheld Programmer Operations Manual
Y1-03-0272 Rev. F Company Confidential Page 51
11. Components and Optional Equipment
The following subsections provide information on system component part numbers and
optional equipment.
11.1 System Component Part Numbers
The Artex Handheld Programmer is being offered as a complete kit (8700) with the
following parts:
Antenna, ¼ Wave Flexible Whip 418 MHz
Holster, Padded ELT Test Set
Cable, C406/110 Series Programming
Cable, C406-N/PA Series Programming
Cable, ME406 Series Programming
Cable, ELT 3000 Series Programming
Any of the above part numbers may be ordered as a replacement or as a separate line
item. Contact the Artex Customer Service department at 1-800-432-0227 or (954) 981-
3333 for details.
11.2 Optional Equipment
If national or local regulations require that the ELT be attenuated and/or directly
connected to the Handheld Programmer, the following parts may be used:
500-3000 Attenuator, 30 dB
611-9010 Cable, Coax 6 ft. TPS to BNC (For Dual Output ELT)
611-6013 Cable, Coax BNC to BNC (For Single Ouput ELT)
Commercial equivalents of any of these parts may also be used.
To Next Page
Loading...
