ASA Electronics XRV10 - Page 30

30
XRV10
Audio Output and Volume Adjustment
In camera mode, if Camera 1 is not triggered, the front audio output will be the from the last audio
source played. Rotate the VOL control (1) to adjust the volume of the audio source. When Camera 1 is
triggered and the Auto Mic Enable feature is on, the camera 1 video appears on the entire screen and
the audio input from the camera is played. In this case, rotate the VOL control (1) to adjust the volume
when Camera 1 is triggered.
NOTE: The upper area of the screen is the current playback information bar area. Press the top of
the screen to remove the bar or make the bar reappear.
Camera Control Options
Touch the lower part of the screen to make the camera controls appear.
. Touch the “CAM 1” Button to view the Camera 1 video in full screen.
. Touch the “CAM 2” Button to view the Camera 2 video in full screen.
.Touchthe“CAM3”ButtontoviewtheCamera3videoinfullscreen.
. Touch the “AUDIO” Button to turn the Camera audio ON/OFF.
. Touch the Button on the screen to change Brightness, Contrast, Saturation and Hue settings.
Usethe+/-buttonstoadjusteachsettingfrom0-20.