ASA Electronics XRV10 - Care and Maintenance

34
XRV10
CARE AND MAINTENANCE
1. Never disassemble or adjust the unit without any professional guidance.
For details, please consult any professional car shop / dealer for inquiry.
2. If the front panel or TFT monitor is dirty, please use a clean silicone cloth and neutral detergent to
wipe o the spot. Using a rough cloth and non-neutral detergent such as alcohol for cleaning may
result in scratching or decoloration to the monitor.
3. Ifanyabnormalbehavioroftheunitisfound,pleaserefertotroubleshootingguideofthismanual.
If no relevant information is found, please press the [RESET] key on the front panel to resume factory
default.
4. If you have parked the car in hot or cold weather for a long time, please wait until the temperature
in the car becomes normal before operating the unit.
5. Using the car heater in low temperature environment may result in moisture inside the unit, DO
NOT use the unit in this situation. If the unit still doesn’t work after a few hours, please contact the
service center.
6. Do not impact the LCD monitor which could cause damage.
7. To prevent damage to the screen, avoid touching it with sharp objects.
8. Toprovideacleardemonstrationandanalternativeforeasyunderstandingtotheoperationofthis
unit, graphic illustrations are used.
However, some illustrations are dierent from the actual images displayed on the screen.
9. Operate the unit correctly according to this manual to prevent unnecessary problem. The guarantee
won’t be valid if the problem is caused by inappropriate operation.