Firmware Update
The cooking hob is equipped with a Wi-Fi module that you could use to receive updates of the
appliance firmware (for example, improved function updates or safety-relevant updates). This requires
that the cooking hob is connected to the cloud and paired with a registered user account on the
ConnectLife-app. If this is not yet established, consult chapter 'ConnectLife and Wi-Fi'.
When new firmware is available, a notification is sent to the ConnectLife-app. Please follow the
instructions.
To start the update process, the cooking hob needs to have the FoA setting set to ON in the settings
menu (see ‘Settings’). This confirms your presence at the cooking hob. After 90 minutes, this setting
is automatically reset to OFF.
After the FoA setting on the cooking hob is set to ON, start the update process on your
ConnectLife-app. The cooking hob will switch OFF. As an indication, the Wi-Fi symbol flashes during
the process. Depending on the configuration, the update process can take up to 60 minutes.
NOTE!
During the update process, you cannot use the hob. The hob will restart several times and will
not respond for periods. Make sure that the power supply and the Wi-Fi connection are not
interrupted during the update.
If the update fails, the hob will remain on the previous firmware version and operate as usual. Try again
after a short period of time. If the update continues to fail, please get in touch with the service
department for further assistance.
If the hob is not responding after updating, it may not have completed the update. Wait for the update
process to complete. If the hob still does not respond after a while, please contact the service
department for further assistance.
43
ConnectLife and Wi-Fi
To Next Page
Loading...
