The cooking zone switches off automatically
after:
Setting
9 hours1 and 2
6 hours3, 4 and 5
4 hours6, 7 and 8
3 hours9
2 hours10
1 hour11 and 12
The cooking-time limiter switches the cooking zones off if the time in the table has elapsed.
The cooking zone switches automatically to
setting 12 after:
Setting
10 minutesBoost
NOTE!
The Cooking-time limiter for the specific cooking zone is reset after the user has changed the
cooking level of the specific cooking zone.
NOTE!
Cooking zone related timers take priority over the cooking-time limiter.
‘Open window’ function
If it is prescribed that an extraction unit, which is located in a room where a fireplace is present, may
only be used when a (kitchen) window is open, then a window sensor must be installed.
The ‘open window’ function is automatically activated as soon as an ‘open window’ sensor is
connected to the appliance. The use of an ‘open window’ sensor type ‘FDS 100’ is recommended.
Power management
This induction hob is equipped with a smart power management system. This system ensures a
maximum permissible power cannot be exceeded for safety reasons.
• The smart power management system will arrange the power distribution across the zones
automatically. This means the hob could automatically decrease the power on one zone when
the power level of another zone is increased. The level of activity of the power management
system depends on the available power per electrical phase, the setting of the current limiter
and the connected load.
• The power level of one zone can affect the power of another zone as the maximum available
power is distributed among the zones. If the combined zones reach the maximum available
power when a new power level is set, the power levels of one or more zones are automatically
reduced within the power limit. This is indicated by the flashing of the relevant control element.
• In case a zone is used for Celsius°Cooking
TM
, this zone always gets the highest priority.
9
Safety
To Next Page
Loading...
