Assa Abloy Aperio C100 V3 - Product Accessories; Product and accessory groupings

47
EN
Accessories
Product / product group
A type CR2 3 V lithium battery for the power supply of the electronics in the knob
cylinder is included in the scope of delivery of the electronic knob cylinder C100V3.
A replacement battery can be ordered separately (“Maintenance”, page48):
CR2 lithium battery with min. 800 mAh 5 0 5 Z B – B A T T – – – 0 0
A special tool is required for battery replacement:
Battery replacement tool 5 0 5 Z B – K – T O O L – – – 0 1
The programming application tool with controller and USB dongle is not included
in the scope of delivery of the electronic knob cylinder C100V3. The software can
be ordered separately:
PAP Software Set 5 0 0 Z B – P A P U S B – 0 0
PAP Software Set Aperio™ Offline 5 0 0 Z B – P A P U S B D 0 0
The following hubs are suitable for the electronic knob cylinder C100V3:
Communication Hub RS485 Aperio™ Protocol 5 0 0 – – – – – – – 1 0 – 0 0
Radio DAC/DAC100 5 0 0 – – – – – – – 20 – 0 0
Communication Hub Wiegand simple 5 0 0 – – – – – – – 3 0 – 0 0
Communication Hub 1toS RS485 5 0 0 – – – – – – – 4 0 – 0 0
Communication Hub Wiegand advanced 5 0 0 – – – – – – – 6 0 – 0 0
Communication Hub IP (Internet Protocol) 5 0 0 – – – – – – – 8 0 – 0 0
The following knob cover is suitable for the electronic knob cylinder C100V3 (inside
and outside knob):
Stainless steel cylinder knob cover 5 0 5 Z B – K C S T – – – 0 1
The knob can be equipped with a turning aid in order to facilitate turning for
disabled persons.
Turning aid 5 0 5 Z B – K C T A – – – 0 1
Accessories
Approved 2017-08-16