36
EN
Notices
Explanation of terminology for the half cylinder
Term Description
I
Knob
(electronic side,
outside)
Knob on the electronic side consisting of:
· cylinder knob cover (
1 ),
· battery compartment (
9 ) for CR2 battery ( 3 ) and
· knob mount (
8 ).
1
Cylinder knob cover The cylinder knob cover is a cover for the knob cylinder C100V3.
2
Special tool
(optional)
The knobs can be removed using special tool.
3
CR2 battery The CR2 battery supplies power to the electronic knob cylinder C100 V3.
4
Bolt washer The bolt washer is screwed into the respective side with the knob holder.
It has a flat area and a point-shaped marking that must point in the
direction of the cylinder housing on both sides.
5
Guide The guide on the locking disc guarantees that the knob is mounted
correctly.
6
Securing sleeve The securing sleeve is fitted on the part of the knob spindle protruding
from the cylinder housing. It accommodates the connecting cable (flex-
ible connector) on the cylinder housing (
7 ).
7
Cylinder fixing screw The knob cylinder is fixed in the mortise lock by the cylinder fixing screw.
8
Cylinder housing The cylinder housing is installed in the door with the cylinder fixing screw
(
6 ). The connecting cable (flexible connector) to the battery compart-
ment (
9 ) is exposed when you remove the knob.
9
Knob mount The knob on each side is inserted in the knob mount and screwed
together with the bolt washer (
6 ). In the process, there is only one way
to fit the parts together, which is determined by the position of the bolt
washer.
10
Battery
compartment
The battery compartment is screwed into the knob spindle with the knob
mount (
8 ). A CR2 3 V battery ( 3 ) must be inserted.
11
USB interface The USB interface is used for setting up the cylinder with the PAP tool
(software for configuring door systems) and for firmware updates.
Approved 2017-08-16
To Next Page
Loading...
Need help?
General
