80-9360-1043-020 Rev 1 05/21
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
16
6000 Series Programming Instructions
To Update 6000 Wi-Fi Inverter Firmware
1. Copy .BIN le to USB drive.
2. Insert USB drive into USB port on side of inverter.
(Figure 21)
3. Press and hold LOAD button for 3 seconds. Release LOAD
button when all LEDs light up.
4. WARNING screens will appear. Once Warnings have
stopped, scroll up to Update FIRMWARE screen.
(Figure 22)
5. Press joystick right to update.
6. Conrm update by pressing joystick right. (Figure 23)
7. Once updated, Update SUCCESS! will appear on screen.
Press joystick right to continue. (Figure 24)
8. Remove USB from port.
9. Once inverter has updated, screen will power off
and back on. Unit is now ready for any additional
adjustments. (Figure 25)
Update FIRMWARE
to V0.78? YES
Conrm Update
YES
Update SUCCESS!
OK
Door SETUP
Requried YES
Figure 21
Figure 22 Figure 23
Figure 24 Figure 25
To Next Page
Loading...
