ASTECH LDM41A - PR - Reset Settings

Commands and Parameter LDM41A and LDM42A Manual
Page 40 ASTECH GmbH
8.31 PR – reset settings
PR resets all parameters (except baud rate). After this a new configuration of
the LDM41A and LDM42A is necessary
average value[SA].................1
display format[SD]................d
measure time[ST]..................0
scale factor[SF]..................1
error mode[SE]....................1
ALARM center[AC]..................1000
ALARM hysterese[AH]...............0.1
ALARM width[AW]...................100000
distance of Iout=4mA [RB].........1000
distance of Iout=20mA [RE]........2000
remove measurement [RM]...........0 0 0
trigger delay, trigger level[TD]..0 0
trigger mode, trigger level[TM]...0 1
baud rate[BR].....................9600
autostart command[AS].............ID
distance offset[OF]...............0
Use instead of PR the "Set Standard" command from Windows
program LDMTool.