ASTECH LDM41A - 2 Safety Instructions; General Safety Instructions; Intended & Conforming Use; Nonconforming Use

LDM41A and LDM42A Manual Safety Instructions
ASTECH GmbH Page 9
2 Safety Instructions
2.1 General Safety Instructions
These safety and operating instructions should be carefully read and followed
during practical work with the LDM41A and the LDM42A.
There is danger of Laser radiation or electrical shock. For necessary
repair work, the LDM41A and the LDM42A may not be opened by
anyone other than Manufacturer personnel. Unauthorized
intervention into the inner product space will void any warranty
claims.
Compliance with all specified operating conditions is necessary.
Failure to observe advisory notes or nonconforming product usage may cause
physical injury to the user or material damage to the LDM41A and the
LDM42A.
Cable connectors must not be plugged or unplugged under voltage.
Remember to turn voltage supply off before you begin working on cable
connections.
2.2 Intended & Conforming Use
 Measurement of distances
 Special measuring functions
 Compliance with prescribed temperatures for operation/storage
 Operation at correct voltage level
 Application of specified signal levels to the appropriate data lines
2.3 Nonconforming use
 Do not operate the LDM41A and the LDM42A in any other way than
described under "Intended & Conforming Use" above and only in a
proper working condition
 Safety devices must not be defeated or otherwise rendered
ineffective
 Information and warning signs must not be removed