Error Codes LDM41A and LDM42A Manual
Page 50 ASTECH GmbH
11 Error Codes
Table 10 : Error Codes
Reflexes are too weak, or distance
from LDM (front edge) to target is
less than 0.1 m
Use white target board
26
or
increase distance to target
Use white target board or
filter
Too much steady light (e.g. sun) or
reflexes are too strong
Use aperture or filter or
white target board
DX mode (only LDM42A): reflexes
too weak, or distance from LDM
(front edge) to target is less than
0.1 m
Use white target board or
increase distance to target
Inner temperature below – 10°C
Inner temperature above + 60°C
Failed to set avalanche voltage
Excessively high Laser current /
Laser defect
SF must be unequal of zero
or necessary to repair
Hardware error, PLL range
Wrong parameter, wrong
command
e.g. 3M, self adhesive foil matte white
To Next Page
Loading...