ASTECH LDM41A - 10 List of Commands

List of Commands LDM41A and LDM42A Manual
Page 48 ASTECH GmbH
10 List of Commands
Table 9 : List of commands
Command
Description
DT
Starts distance tracking
DS
Starts distance tracking (< 7 m)
DW
Starts distance tracking on white target at 10 Hz
DX
Starts distance tracking on white target at 50 Hz (only
LDM42A)
DF
24
Starts remote-triggered single distance measurement
(single shot)
DM
Starts single distance measurement (single shot)
TP
Queries inner temperature
SA
Queries / sets floating average value (1...20)
SD
Queries / sets output format (dec/hex/sig)
ST
Queries / sets time to measure (0...25)
SF
Queries / sets scale factor
SE
Queries / sets error mode (0, 1, 2)
AC
Queries / sets alarm center
AH
Queries / sets alarm hysteresis
AW
Queries / sets alarm with
HO
25
Queries / sets temperature for heating on
HF
25
Queries / sets temperature for heating off
RB
Queries / sets beginning of range (4 mA)
RE
Queries / sets end of range (20 mA)
RM
Queries / sets removal measurement parameters
TD
Queries / sets trigger delay and level
TM
Queries / sets trigger mode and level
BR
Queries / sets baud rate
AS
Queries / sets auto start
24
Trigger function is not available for devices with internal heating (LDM41A-h and LDM42A-h)
25
Only for devices with internal heating (LDM41A-h and LDM42A-h)