Astoria AEP - Dispensing Coffee, Steam, and Hot Water

USER manual
56 of 260
6.6 Dispensing of the coee
6.6.1 AL version
• Put the coee cup under
the dispensing spout
• pull the lever all the way
down;
• wait for the short coee
pre-infusion time (3÷5
seconds);
• lift the lever until some
resistance is felt, then
release it;
• wait until coee delivery
is complete.
Never perform the above actions without coee in the lter or
without the filter holder attached to the delivery group. The
rapid upward movement of the lever may cause damage to the
appliance, individuals or property.
Delivery time deepens on grinding and the amount of coee in
the lter holder.
6.6.2 AEP version
• Put the coee cup under the
dispensing spout
• Press the desired delivery
switch. The delivery will begin,
and it can be stopped using the
same switch once the desired
amount of coee is obtained
in the cup.
6.6.3 SAE - DISPLAY version
PROGRAMMING
The machine is programmed
by default. Should coee doses
need to be modied, proceed as
follows:
• Always programme the right-
hand push-button panel rst.
In this way all push-button pan-
els get programmed automati-
cally. If necessary programme all
the others subsequently;
• Position the cup under the dis-
pensing spout;
• Press button
STOP
PROG.
for at least 5
seconds until all leds of the dose
buttons are lit;
• Press the wanted dose button,
for example
STOP
PROG.
;
• to conrm the dose, press but-
ton
STOP
PROG.
again, or button
STOP
PROG.
;
• repeat this operation for the
other dose buttons;
• on concluding the programming, press button
STOP
PROG.
until all leds of the push-button
panel are switched o.
The programming of every dose must be carried out with ground
coee and not with previously used coee dregs.
STOP
PROG.
STOP
PROG.
STOP
PROG.