Rubber Track Loader
7. Radiator/Oil Cooler Disassembly and Assembly
7-5
5. Remove rear engine skid plate from the ma-
chine. This will give you access to the bottom
radiator hose and bottom hydraulic hoses.
Figure 7-12
6. Remove the lower radiator hose from the radia-
tor section.
Figure 7-13
7. Remove the two bottom hydraulic oil cooler
hoses. Cap and plug the fittings and hoses.
Figure 7-14
8. Remove the three bolts on each side of the Ra-
diator/Cooler, which fasten it to the frame.
Figure 7-15
9. Pull the radiator/cooler straight up. It may be
necessary to move the fan shroud out of the way
for the radiator/cooler to clear.
To Next Page
Loading...