Rubber Track Loader
11. Maintenance
11-3
Figure 11-2
2. Clean the area around the hydraulic filters.
Figure 11-3
3. Turn the hydraulic filters counter clockwise, re-
move the filters and replace.
4. Fill with manufacturer-approved hydraulic fluid.
Fuel-Water Separator
Figure 11-5
1. Twist the drain counter-clockwise to drain water
from the bowl.
Figure 11-6
Fuel Filter
The fuel filter should be changed every 500 service
hours, or as needed. A plugged fuel filter can cause
loss of engine power, rough running, or no start.
NOTICE
Collect and contain liquids in a suitable container. Dispose
of all liquids according to local regulations and mandates.
Hydraulic
Filters
Case Drain Filter, change only if an
attachment with a case drain has a
drive motor failure.
Drain
To Next Page
Loading...