Atag XL75W - Page 74

74
Operation
Parameter listing
Menu Submenu Parameter Name Description Range Factory settings
26..32. 20 Other
26..32. 20. 0
DHW modulation setpoint °C
42 Building Management System
42. 0 General
42. 0. 0
BMS Control Mode
Disabled
Voltage Power
Voltage Temp
Current Power
Current Temp
External Controller Power
External Controller Temp
42. 0. 1 BMS Max Temp °C
42. 0. 1 BMS Min Temp °C
42. 1 Analog Level Settings
42. 1. 0
V
42. 1. 1 BMS Analog Control Voltage to Stop Heat Demand V
42. 1. 2 BMS Analog Control Voltage for Maximum Heat Demand V
42. 1. 3 BMS Analog Control Voltage for Minimum Heat Demand V
42. 1. 4 BMS Analog Control Current to Start Heat Demand mA
42. 1. 5 BMS Analog Control Current to Stop Heat Demand mA
42. 1. 6 BMS Analog Control Current for Maximum Heat Demand mA
42. 1. 7 BMS Analog Control Current for Minimum Heat Demand mA
42. 2 Diagnostics
42. 2. 0
BMS Status
Absent
Disabled
OFF
Standby
Heat Request
&RQ¿J(UURU
42. 2. 1 BMS Level %
42. 2. 2 BMS SetPoint °C
42. 2. 3 BMS Input Voltage V
42. 2. 4 BMS Input Current mA