Dial Mode (#201)
Description
This system option identifies incoming lines as touch-tone or rotary. You should
check with your local phone company if you are not sure which type of line is
being provided to you.
Valid Entries
1 = Touch-Tone lines
✔
2 = Rotary lines
Changing Settings
To change the Dial Mode setting for the system, follow these steps from
extension 10:
1.
2.
3.
4.
5.
6.
Press [ Feature ] [ 0 ] [ 0 ].
The phone beeps once, and the light next to [
Spkr
] is green flutter.
Press left [ Intercom ] twice.
The light next to [
Intercom ] is green steady.
Press [
#
] [
2
] [
0
] [
1
].
The Message light is red steady if the current setting is Touch-Tone lines,
red flash if the current setting is Rotary lines.
Press [
1
] to select Touch-Tone lines, [
2
] to select Rotary lines.
The Message light changes to show the new setting.
If you make a mistake, begin again at Step 3.
When you are finished, press [
#
] and a three-digit code for another option or
press [ Feature ] [ 0 ] [ 0 ].
5-12
Dial Mode (#201)
To Next Page
Loading...
