Syn248 Installation and Configuration Guide Back to Contents
Installation 29
To install a music on hold source:
1. Connect an audio cable with 1/8-inch (3.5 mm) jacks from your music on hold source
to the “Music on Hold Input” jack of the audio in/out cable supplied with the
SB35025 Deskset. See Figure 15.
Figure 15. Music on Hold Source Installation
2. Connect the supplied audio in/out cable to the SB35025 Deskset AUX I/O port.
3. Log on to the WebUI to configure the Music on Hold settings. See “Accessing the
Administrator WebUI” on page 36. The Music on Hold settings are listed under Hold
Settings in the WebUI. You must:
Enable Music on Hold.
Select the extension (Deskset) to which you have connected the music on hold
source.
For more information, see “Configuring Hold Settings” on page 49.
SB35025 Deskset
Music on Hold Source
Music on Hold
Input
To Next Page
Loading...
