104
Call block
Call block
Using the telephone base:
Press MENU in idle mode.
Press CID or DIR to highlight Call block, then press
SELECT .
Press SELECT again to select Block list.
Press CID or DIR to highlight Add new entry, then
press SELECT .
The screen displays ENTER NUMBER. Use the dialing keys
to enter a telephone number (up to 30 digits).
Press CID or DIR to move the cursor to the left
or right.
Press BACKSP or X/DELETE to erase a digit.
Press and hold X/DELETE to erase all digits.
Press and hold REDIAL/PAUSE to insert a three-second
dialing pause (a p appears).
-OR-
When the screen displays ENTER NUMBER, press
REDIAL/PAUSE
to copy
a number from the redial list.
Press
CID or DIR
, or press REDIAL/PAUSE
repeatedly to locate the desired number. Press
INSERT
to copy the
displayed number.
Press NEXT to move on to the name.
The display shows Number already saved if the number is already in the
call block list. You cannot save the same number twice.
The screen displays ENTER NAME. Use the dialing keys to enter a name (up
to 15 characters). Press a key repeatedly until the desired character shows
on the screen (see Character chart on page 87).
Press CID or DIR to move the cursor to the left or right.
Press BACKSP or X/DELETE to erase a character.
Press and hold X/DELETE to erase all characters.
Press 0 to add a space.
Press a>A to change the next letter to upper or lower case.
Press SAVE to store your call block entry.
1.
2.
3.
4.
5.
•
•
•
•
6.
•
7.
•
•
•
•
•
8.
Directory
Caller ID log
Intercom
Call block
BACK SELECT
CALL BLOCK
Block list
Calls w/o num
BACK SELECT
BLOCK LIST
Review
Add new entry
BACK SELECT
To Next Page
Loading...
