111
Answering system
Answering system settings
Answer on/off
If you turn the answering system on, it answers calls and records messages
only on the home line. If your paired cell phone has voicemail, callers can leave
messages with that voicemail service.
If your answering system is turned off and you change any of its settings, the
answering system automatically turns on again.
When the answering system is turned on, the /ANS ON light on the telephone
base is on. Both the handsets and telephone display ANS ON.
To turn the answering system on or off:
Using a handset:
Press MENU in idle mode.
Press CID or DIR to highlight Answering sys, then press
SELECT.
Press CID or DIR to highlight Answer ON/OFF, then
press SELECT.
Press CID or DIR to highlight On or Off, then press
SELECT to save. You hear a confirmation tone.
Using the telephone base:
Press /ANS ON to turn the answering system on or off.
When the answering system is turned on, it announces,
“Calls will be answered.” When the answering system is
turned off, it announces, “Calls will not be answered.”
-OR-
Press MENU in idle mode.
Press SELECT to select Answering sys.
Press CID or DIR to highlight Answer ON/OFF, then press SELECT.
Press CID or DIR to highlight On or Off, then press SELECT to save. You
hear a confirmation tone.
NOTE: If the answering system is off and there is an incoming call, the system answers after
ten rings and announces, “Please enter your remote access code.” For more information about
remote access, see pages 127-128.
1.
2.
3.
4.
•
1.
2.
3.
4.
ANSWERING SYS
Delete all old
Record memo
Answer ON/OFF
BACK
SELECT
ANSWER ON/OFF
On
Off
BACK
SELECT
To Next Page
Loading...
