AT&T TL96456 - Add a Call Block Entry

103
Call block
Call block
Add a call block entry
Using the handset:
Press MENU in idle mode.
Press CID or DIR to highlight Call block, then press SELECT.
Press SELECT again to select Block list.
Press CID or DIR to highlight Add new entry, then press SELECT.
The screen displays ENTER NUMBER. Use the dialing keys to enter a
telephone number (up to 30 digits).
Press CID or DIR to move the cursor to the left or right.
Press BACKSP or MUTE/DELETE to erase a digit.
Press and hold MUTE/DELETE to erase all digits.
Press and hold REDIAL/PAUSE to insert a three-second dialing pause
(a p appears).
-OR-
When the screen displays ENTER NUMBER, press REDIAL/PAUSE to copy
a number from the redial list. Press CID or DIR , or press REDIAL/PAUSE
repeatedly to locate the desired number. Press INSERT to copy the
displayed number.
Press NEXT to move on to the name.
The display shows Number already saved if the number is already in the
call block list. You cannot save the same number twice.
The screen displays ENTER NAME. Use the dialing keys to enter a name (up
to 15 characters). Press a key repeatedly until the desired character shows
on the screen (see Character chart on page 87).
Press CID or DIR to move the cursor to the left or right.
Press 0 to add a space.
Press BACKSP or MUTE/DELETE to erase a character.
Press and hold MUTE/DELETE to erase all characters.
Press a>A to change the next letter to upper or lower case.
Press SAVE to store your call block entry.
1.
2.
3.
4.
5.
•
•
•
•
6.
•
7.
•
•
•
•
•
8.